Die Cast

The range includes photo dome lapel pins made as flat medallion-style pins with a printed design applied to the surface. The printed artwork is placed onto the metal base and covered with a clear epoxy dome.

The epoxy layer sits over the printed design and creates a smooth surface across the face of the pin. This method allows full colour reproduction, including fine detail and gradients.

Branding is printed, positioned on the front of the pin, and sealed with an epoxy coating.

Good to Know

How does this differ from enamel pins?

The design is printed rather than filled into recessed areas, allowing more detail and colour variation.

Where is the epoxy applied?

The epoxy is applied over the front of the pin, covering the printed design.

Are these suitable for detailed logos?

Yes. Printed designs allow for fine detail that cannot be achieved with enamel fill.

Who typically uses these pins?

They are used by organisations, clubs, and businesses where detailed artwork or full colour designs are required on a pin.